Trapcode 3D Stroke
Trapcode 3D Stroke comes packaged within a Trapcode Suite installer file. Since Trapcode 3D Stroke is a plug-in, you must first have installed a compatible host program (e.g., Premiere or After Effects). Once the installer launches and its prompts have been followed, the installer will automatically place the required Trapcode 3D Stroke components onto your system.
The Trapcode Suite installer can also install the other products in Trapcode Suite if selected.
Note that products install in trial mode by default unless you supply that product’s serial number prior to installation. This allows you to use purchased products and try new products before you buy.
This page explains how to install the Trapcode product(s).
The Trapcode Suite installer gives general host and OS specifications and requirements. Since this page is only updated as recently as the installer's release, some information may be outdated.
Review this page for the current Trapcode 3D Stroke system requirements.
The installer will give you a choice of installing your Trapcode plug-in as a licensed or trial version product. If you have a serial number for a product or the suite, enter it into the serial number prompt and click Submit .
If no serial number is input, your Trapcode product will install in trial mode. Running in trial mode lets you try out a Trapcode product before you purchase it. When running under a trial mode, your project may show a red X watermark across the image in both previews and final renders, be a time-limited trial, or have keyframe limitations. Aside from that, the Trapcode product is fully functional.
Trapcode products will install into the compatible host application(s) you check off. Make sure you check at least one host application for installation or the Trapcode Suite plug-in(s) will not install.